Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Did I measure this squish correctly?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Heilman181" data-source="post: 4720143" data-attributes="member: 8423"><p>After checking my squish, I found a picture (posted by Mastermind, I think) where the solder was U-shaped with the open end towards the edge of the piston. </p><p></p><p>I like this idea better. It just seems safer than worrying about a small piece of solder falling down into the bottom end. </p><p></p><p>Sent from my SPH-D710 using Tapatalk</p></blockquote><p></p>
[QUOTE="Heilman181, post: 4720143, member: 8423"] After checking my squish, I found a picture (posted by Mastermind, I think) where the solder was U-shaped with the open end towards the edge of the piston. I like this idea better. It just seems safer than worrying about a small piece of solder falling down into the bottom end. Sent from my SPH-D710 using Tapatalk [/QUOTE]
Insert quotes…
Verification
Post reply
Top