Saucydog
ArboristSite Operative
Well,right or wrong,I did my own "muffler mod" yesterday by boring a 1/2" hole out of my non-etech muffler via the front muffler support.Other than making it louder, it seems to have opened the saw up a bit-ran 2 tanks through it today,it seems a little quicker in the cut than before.My question:is there anything I should be wary of?Are there any specific carb. adjustments I oughta make now or certain gas\oil mixes I should run?It appears to be running as reliably as ever-I just don't want to do any real harm to the engine if possible.The 357 is my only saw right now;'til I figure out why the old 028 super won't start.(a hard lesson learned from lending out your saw!)Any tips or advice on the proper diy mods would be greatly appreciated-Thanks.