Want to Sell Dolmar 3410TH

[miller755]

These have pretty good power, but poor balance. Not the best in the tree IMO. Great for a small light ground saw. Good torque due to reed valve intake.

Great on the ground, 14" or 16" available IIRC.

Complete dissassembled parts saw can go with.

Start at 225 + shipping.

 

[miller755]

Compression is 140 or 150, ill add the photo if i can find it.

 

[miller755]

200+ shipping

 

[HansFranz]

Does it run? How's it run?

I have same saw, not sure whether the reed box always gets loose and develops a small air leak or what, but I've always had trouble with tuning it rich enough. Seems like it always wants to run away no matter how rich I set it. (I also muff modded mine.)

 

[miller755]

Runs great. Never had an issue with it, had it 2-3 years. Put a carb kit in it when I got it, before the carb kit it didn't run right. Muffler modded. Tunes fine, iirc these are different in the order you tune them. Or some specific procedure. Idk it was a couple years ago. Choke is a little tricky on these too. Gotta make sure it's choked. Also can draw in unfiltered air thru tuning screw holes. I put black duct tape over holes.
I would keep it but I have a Chinese 25cc a 193t and a 355t that is modded. So my top handle needs are covered.
As I mentioned it comes with a complete disassembled parts saw. I don't think anything was wrong with the parts saw before dissassembly.