mstang1988
ArboristSite Operative
I have a few saws that I’m trying to decide what to do with. I long while back I big bore swapped the 6401. During tuning I killed the clutch being oblivious that the break was on. The saw has sat for a few years so probably a gummed carb too.
Long story short, I’d like to just go with a built 7900 OEM top end (ported etc) and supporting mods (MM). I’m looking for somebody that would do all of this work.
I also have a Makita 9000. It needs the coil and flywheel swap (have them) to the 9010. It ran when I last put it down but I haven’t gotten it to pop recently so again, so suspect a carb rebuild (although I have the kit on order and may do that myself). Looking at getting it ported and MM as well.
Both are used saws. Any suggested builders that would pick these projects up?
Long story short, I’d like to just go with a built 7900 OEM top end (ported etc) and supporting mods (MM). I’m looking for somebody that would do all of this work.
I also have a Makita 9000. It needs the coil and flywheel swap (have them) to the 9010. It ran when I last put it down but I haven’t gotten it to pop recently so again, so suspect a carb rebuild (although I have the kit on order and may do that myself). Looking at getting it ported and MM as well.
Both are used saws. Any suggested builders that would pick these projects up?