Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Milling & Saw Mills
Milling bar for Jonsered 920
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="srcarr52" data-source="post: 3223487" data-attributes="member: 39776"><p>The D024 mount is a 10mm width slot where the D009 (Large Husqvarna) is 9.5mm. I think the bar profile are about the same but the oil hole on the D009 is a little farther forward (1/2") then the D024 mount. So you can grind the D009 out to 10mm or take 0.5mm off the bar stud shoulder diameter. The oil hole will probably still line up with the oil galley unless you are getting out to the far extent of the bar adjustment, then you could just drill a new oil hole in the bar.</p></blockquote><p></p>
[QUOTE="srcarr52, post: 3223487, member: 39776"] The D024 mount is a 10mm width slot where the D009 (Large Husqvarna) is 9.5mm. I think the bar profile are about the same but the oil hole on the D009 is a little farther forward (1/2") then the D024 mount. So you can grind the D009 out to 10mm or take 0.5mm off the bar stud shoulder diameter. The oil hole will probably still line up with the oil galley unless you are getting out to the far extent of the bar adjustment, then you could just drill a new oil hole in the bar. [/QUOTE]
Insert quotes…
Verification
Post reply
Top