Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Need 088 muffler help/advice
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="atpchas" data-source="post: 7028930" data-attributes="member: 21290"><p>That would be an elegant solution (and an excuse to buy a new tool, too - double bonus) but it appears Rivnuts are designed to go through sheet metal and the threaded hole is not much smaller than the OD. My best guess (based on the tap size that appears to be a good fit) is that the hole in the muffler is M11x1.5 while the bolt that threads in to it is an M5.</p><p>Thanks for the suggestion, though. I've put a Rivnut installer on my watch list.</p></blockquote><p></p>
[QUOTE="atpchas, post: 7028930, member: 21290"] That would be an elegant solution (and an excuse to buy a new tool, too - double bonus) but it appears Rivnuts are designed to go through sheet metal and the threaded hole is not much smaller than the OD. My best guess (based on the tap size that appears to be a good fit) is that the hole in the muffler is M11x1.5 while the bolt that threads in to it is an M5. Thanks for the suggestion, though. I've put a Rivnut installer on my watch list. [/QUOTE]
Insert quotes…
Verification
Post reply
Top