I just got an Echo PPT265S with a 12" bar. What is the safe cutting capacity?
Thanks, I had no idea it would handle that large a limb.In theory you can saw from both sides, and cut a branch that is twice the diameter of your guide bar. In practice, this is harder to do on a hanging limb then a log on the ground.
You can notch a limb from one side, then finish it from the other. But you are usually cutting at an angle, and often have limited access, which reduces the effective bar length. And, as noted, you need to be careful not to get the bar pinched, as it is harder to clear than with a log on the ground.
So I would say a rule of thumb is the length of the bar on the pole saw is a practical maximum for the diameter of limb that you can cut.
Philbert
Depends on wood species and chain sharpened how fast the cutting is going to take place. I know with mine I can knock down enough branches in a short time that will turn into a chore hauling them away.I know the feeling. I don't paln to use it for heavy limbs, but I was curious.
Sent from my iPhone using Tapatalk
I don't paln to use it for heavy limbs, but I was curious.
I have a large Live Oak next to my houe. The pole pruner will make trimming from either the ground or on the roof much easier.Another advantage of a pole saw is reach. Dealing with storm damaged trees and limbs, I can reach in from a safe distance to relieve stress, instead of wading in among the branches. Sometimes can also be used to free up a hung up tree or branch without getting too close.
http://www.arboristsite.com/community/threads/oregon-40-volt-pole-saw.248941/
Philbert
Wait till the winter to prune that live oak if possible
Enter your email address to join: