Slow idle down

[woodyman]

One of my Husky 44's just does not what to slow down that fast after coming out of a cut.It does slow down to idle but slowly.Anyone run into this before or have any thoughts before I tear into it.Thanks.

 

[nmurph]

How far out is the L needle? I don't the correct setting (probably one turn out), but you can back it out a little more. If you have to go more than 3/4 or so turns beyond the factory spec, I would bet you have an air leak.

 

[woodyman]

How far out is the L needle? I don't the correct setting (probably one turn out), but you can back it out a little more. If you have to go more than 3/4 or so turns beyond the factory spec, I would bet you have an air leak.

Thanks,hope it's not an air leak.I am going to retune it as soon as I get done changing oil in the truck.This one is ported with no base gasket new crank seals and rebuilt carb.

 

[blsnelling]

One or both the H or L is lean.

 

[woodyman]

One or both the H or L is lean.

Thanks,Brad.Was going to check them after I finish work on my truck and thought I would ask when in the house defrosting my hands.I hate to wear gloves and when it's below freezing I pay.It's not so bad the freezing but the thawing out.