I had a problem with the starter in my Solo twin at the Baraboo event last August.
I took it apart then and discovered (for reasons that do not need exploring at this juncture) that only one pawl was engaging and overloaded the other.
I finally got around to fixing it the past week. First step was to get the broken piece out and make a new one.
Cutting the small groove for the "E" clip was tricking, but searching through the old hacksaw blade store turned up one with just the right thickness.
Parting it off was tricky too, but we managed to get the job done.
Mark
I took it apart then and discovered (for reasons that do not need exploring at this juncture) that only one pawl was engaging and overloaded the other.
I finally got around to fixing it the past week. First step was to get the broken piece out and make a new one.
Cutting the small groove for the "E" clip was tricking, but searching through the old hacksaw blade store turned up one with just the right thickness.
Parting it off was tricky too, but we managed to get the job done.
Mark