Finally got to rebuilding an 028 AV Super that I got from my Father-in-Law.
First time doing this and I've made a few mistakes. Broke a circlip and a fin on the flywheel. All replaceable.
Compression was low, but I'm not sure why. Cylinder doesn't look to be in bad shape. Piston looks like it might be scored a little, but I can't feel them, only see them. What should I do, replace just the piston and rings or piston, rings and cylinder? Where's the best place to get those parts and what are good replacement brands?
I cleaned it up the best I could before I pulled the cylinder, but I know I got some junk in there. What's the best way to clean the crank case without ripping the case apart?
I also found discovered that a few of the annular buffer's were shot. Where's the best place to find all the replacement parts?
Thanks for any help you can provide!
First time doing this and I've made a few mistakes. Broke a circlip and a fin on the flywheel. All replaceable.
Compression was low, but I'm not sure why. Cylinder doesn't look to be in bad shape. Piston looks like it might be scored a little, but I can't feel them, only see them. What should I do, replace just the piston and rings or piston, rings and cylinder? Where's the best place to get those parts and what are good replacement brands?
I cleaned it up the best I could before I pulled the cylinder, but I know I got some junk in there. What's the best way to clean the crank case without ripping the case apart?
I also found discovered that a few of the annular buffer's were shot. Where's the best place to find all the replacement parts?
Thanks for any help you can provide!