brandonstc6
Addicted to ArboristSite
About 3 years ago I rebuilt this saw.
New oem bearings
New oem gaskets and seals
Tecomec piston and rings (made in Italy)
NOS Tillotson carburetor
NOS oem air filter
New fuel line (oem if I remember correctly)
New impulse line (oem if I remember correctly)
Compression is 150 psi.
When I tried to start the saw, it started but it wouldn’t idle down, like it had an air leak. I immediately shut it down and I put it on the shelf and I never did anything with it. I’m sure the carburetor needs cleaning now. And the saw needs to be pressure tested to determine where the air leak is. I have not had time to do so. $100 plus shipping.
Saw is a little dirty from sitting in storage.
Sent from my iPhone using Tapatalk
New oem bearings
New oem gaskets and seals
Tecomec piston and rings (made in Italy)
NOS Tillotson carburetor
NOS oem air filter
New fuel line (oem if I remember correctly)
New impulse line (oem if I remember correctly)
Compression is 150 psi.
When I tried to start the saw, it started but it wouldn’t idle down, like it had an air leak. I immediately shut it down and I put it on the shelf and I never did anything with it. I’m sure the carburetor needs cleaning now. And the saw needs to be pressure tested to determine where the air leak is. I have not had time to do so. $100 plus shipping.
Saw is a little dirty from sitting in storage.
Sent from my iPhone using Tapatalk