Stihl 032 Compresstion ?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

kidd300

ArboristSite Lurker
Joined
Nov 3, 2006
Messages
29
Reaction score
0
Location
Pittsburgh PA
I got 3 032's and all of them with a car tester with the release valve ,all go around 75 to 80 lbs

is this normal all the saws pass the hold test and run great ?

i see some say 150 175 lbs how do you pull them to start ?

Mike
 
Yes i saw the other posts but my results are way off compared too the ones in the other post so what readings do i believe ?

the saws i got are running great start easy


Mike
 
View attachment 40016
Having the same problem with all my saws it struck me:bang: that with the length of the compression tester hose i was essentially increasing the cylinder volume equal to the total volume of cylinder and tube/gauge combined so by shortening the tube as above you will get much more accurate readings. the blue tube is 4mm rigid pneumatic tube which was pussed up inside the two off cuts of rubber tubing thus providing a means of reconnecting the two halves using superglue and also further reducing the volume of air required to fill the gauge.
 
Back
Top