This particular saw I posted about in the Chainsaw forum yesterday for a price check. Looks like I should be asking $475 shipped PHO. PayPal gift. Would trade for a clean turn-key 357xpg, but nothing else.
PRICE DROP 3/10/15 - $425 SHIPPED CONUS.
****************************************************************************************************
This saw is a 10mm 044 with new OEM piston in a clean 10mm cylinder, no base gasket, case split with new bearings and seals, and a dual-outlet muffler (added outlet cut on starter side but with regular front cover). I believe there are a couple thread-serts that were put in, and I know that the case's previous owner had done some clearance grinding for a 12mm crank, and the covers were pulled out of a stash of used pieces I had laying around. I ran it a couple tanks through it, then broke a starter pawl, and didn't run it again until a couple weeks back. It has seen 16.5 tanks since it was rebuilt. It is not beautiful but it is really strong and revs up fast.
Five pulls, cold:
PRICE DROP 3/10/15 - $425 SHIPPED CONUS.
****************************************************************************************************
This saw is a 10mm 044 with new OEM piston in a clean 10mm cylinder, no base gasket, case split with new bearings and seals, and a dual-outlet muffler (added outlet cut on starter side but with regular front cover). I believe there are a couple thread-serts that were put in, and I know that the case's previous owner had done some clearance grinding for a 12mm crank, and the covers were pulled out of a stash of used pieces I had laying around. I ran it a couple tanks through it, then broke a starter pawl, and didn't run it again until a couple weeks back. It has seen 16.5 tanks since it was rebuilt. It is not beautiful but it is really strong and revs up fast.
Five pulls, cold: