D
Deleted member 149229
Guest
Just purchased a used 20" Oregon Powermatch bar for an 039 I just purchased. Bar was ground to clean it up when I bought it, visually rails appeared good. When I ran the saw I a 12" cherry it would cut about half way then just grab/stop. Put the old Stihl bar on and no problem. Put the Oregon bar on and same thing, grab/stop. Stihl bar again, no problem. The second time I took the Oregon bar off I noticed a substantial amount of wood between the chain and the bar. No, I don't have the bar number here, it's out in the shed. My 2 areas to check tomorrow are 1) is the bar a .050. 2) use a square to check rail perpendicularity. Am I missing something obvious?