Wood/chuck chipper performance, size of chipped material?

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Rancilio

ArboristSite Lurker
Joined
Sep 30, 2022
Messages
8
Reaction score
0
Location
Southern Indiana
Hello, As new old Wood/chuck owner, I have a few questions regarding what to expect in my chipped material. When everything is adjusted properly, what should the chipped material look like? Should everything be in chipped form? Should all chips be small, maybe less than 4-5in? I get a quite a few 1-2ft shreds and some 1/2-1in branch pieces come out. I appreciate your experience.
 
My online searching suggests my chipper is very similar to the WC-12 but likely an earlier version. Does the data plate info tell me what year the chipper model year?

The data plate reads,
Serial No. ENG 05517 L2HK
Model No. STWC1666 1000
Frame Mod STC
Rotor Mod SWC
Eng Mod 172
 
Hello,

Your wood chips should never be 4-5 inches. They should be 1-2" size chips. You have some issues as I think your knives are dull. Another issue is that it sounds like the anvil/cutter bar is too far from your knives. From time to time, a branch will go through the machine and it won't chip.. That happens on all chippers. Anvils usually can be flipped as they have 4 edges. The edges should be square. If not, a used edge will look like a rounded off table edge. This creates a larger gap between the knife and anvil which in turn creates a larger wood chip. The distance between the knife and the anvil should be a about a 1/16" gap. When checking for the gap, you should always turn the drum backwards as not to damage the knife or anvil if they were to hit. When you think the gap is correct, then turn the drum by hand in the chipping direction and check the clearance on all of the knives. Please remember to remove the ignition key prior to performing this repair.

The Woodchuck Corporation sold out to Altec many years ago. Altec is no longer supporting Woodchuck chippers that are older than 20 years. Our company can help with bearings, belts, knives, anvils, and clutches if you ever need them. Other parts may need to be machined by a machine shop which can get costly. A WC-12 is a very old machine and the numbers you provided will not help in identifying the year. I've been doing this for many years and I'll about bet you have an old Ford 300 engine in the chipper. It might be a diesel. If you have the engine serial number, you can call the maker with the engine serial number and they should be able to tell you the year.

Hope this helps!

Dave
Global Equipment Exporters
770-420-6400
 
Back
Top