I have what seems to be a limiting screw on the carb needles....either permanent or a slip-on type. I tried to pull them off gently but would not come off...do these come off....I don't wanna break anything.
I opened the H needle as far as the limiter would allow, giving me a 4-cycle blubber at WOT...tach was right between 13.5K and 14K with no chain.
I assume this will change with B&C, so are these set at the factory like this or can I remove these caps?
I opened the H needle as far as the limiter would allow, giving me a 4-cycle blubber at WOT...tach was right between 13.5K and 14K with no chain.
I assume this will change with B&C, so are these set at the factory like this or can I remove these caps?