I go for spurts where I won't take any work, and then I let the flood gates open! I'm trying to pay for a lathe, so need to make hobby money to pay for hobby tools, lol.
Here we have two never fueled MS441R-CMs. One gets the 1/2 wrap handle and a port job later today. The MS460 is ported and ready to be boxed up. The MS201T gets a MM, timing advanced, and the carb limiter drilled out. Then you have my 550XP which arrived back yesterday. I'm trying to decide if it's a rose amongst the thorns, or if it's a bad apple in a barrel of good ones:biggrin: Then there are three 28" ES Light bars there on the ground. It's pretty crazy when you realize there's well over $4K setting there!
Here we have two never fueled MS441R-CMs. One gets the 1/2 wrap handle and a port job later today. The MS460 is ported and ready to be boxed up. The MS201T gets a MM, timing advanced, and the carb limiter drilled out. Then you have my 550XP which arrived back yesterday. I'm trying to decide if it's a rose amongst the thorns, or if it's a bad apple in a barrel of good ones:biggrin: Then there are three 28" ES Light bars there on the ground. It's pretty crazy when you realize there's well over $4K setting there!
Last edited: