Nobody wants to 'feather' a saw through the cut while working. A broad powerband is nice on a work saw.
I think you mean per second not per minute as if that is the case l can walk faster than the chain on your porded sawz.
Hahaha. Yea. I did.
Wiggs was thinkin' about an 090.
Torque is king. Ask anybody who actually uses a saw everyday. Nobody wants a piss revver.
Just some food for thought....
At 12k RPM, a 7 pin 3/8 setup spins at 87.5 feet per second.
At 13k RPM, the same setup spins the chain at 94.79 feet per second.
Changing gears a bit... Lol.
At 12K RPM, an 8 pin rim at 12k rpm spins the chain at 100 feet per second.
And at 13K RPM , an 8 pin spins the chain at 108 feet per second.
If you can maintain 12k in wood, that is, have the torque to pull an 8 pin rim, you WILL be cutting faster than the same saw, running a 7 pin at 13k RPM.
Like I said, torque is king....
or if you're getting paid by the cord and the wood is small.Speed is for cuttin' cookies
^^^^^^^This^^^^^^^Torque for me cutting Ozzy hard woods cant beat it.
One of the fastest saws I've seen to run away from you while idling on the ground. Don't expect them to be where u set them down at. Lmao.I had a David bradley gear drive once. I swear you could file it while you were bucking. Couldn't stall it though...
Dead dogs.
And cats.....and whales.
That's no problem at all IF you make the cut firstTorque. I want to put the chain on backwards and still make it through the cut.
Suprised you didn't throw bush apes in there too!Dead dogs.
And cats.....and whales.
Enter your email address to join: