View attachment 404808 And here's a pic I will prob catch crap over. I am the first to admit I have a lot to learn but here I know the air and gas mix is in a gas form not a liquid but I like to run them under the faucet to try to understand how the trans are flowing. This one in particular the exhaust side trans I may pull the the edge closet to the exhaust a little more straight out on the next build. But like I said this is more me learning how each cylinder flows. And the directions my port work is aiming. On the port you see flowing. Both sides were head towards the intake when I started and you can see how I pulled the middle of the port around just a bit towards the center of the piston.