MillerModSaws and the PS-7910

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
MillerModSaws

MillerModSaws

USE2COULDBESPONSER!
Joined
Jan 3, 2013
Messages
2,025
Location
missouri
20150218_172207.jpg And here's a pic I will prob catch crap over. I am the first to admit I have a lot to learn but here I know the air and gas mix is in a gas form not a liquid but I like to run them under the faucet to try to understand how the trans are flowing. This one in particular the exhaust side trans I may pull the the edge closet to the exhaust a little more straight out on the next build. But like I said this is more me learning how each cylinder flows. And the directions my port work is aiming. On the port you see flowing. Both sides were head towards the intake when I started and you can see how I pulled the middle of the port around just a bit towards the center of the piston.
 
wigglesworth

wigglesworth

Booned
Joined
Oct 5, 2008
Messages
8,175
Location
West kentucky
View attachment 404808 And here's a pic I will prob catch crap over. I am the first to admit I have a lot to learn but here I know the air and gas mix is in a gas form not a liquid but I like to run them under the faucet to try to understand how the trans are flowing. This one in particular the exhaust side trans I may pull the the edge closet to the exhaust a little more straight out on the next build. But like I said this is more me learning how each cylinder flows. And the directions my port work is aiming. On the port you see flowing. Both sides were head towards the intake when I started and you can see how I pulled the middle of the port around just a bit towards the center of the piston.

That's how I do it.

Good looking build sir!
 
MillerModSaws

MillerModSaws

USE2COULDBESPONSER!
Joined
Jan 3, 2013
Messages
2,025
Location
missouri
Its going to loose some of the charge out the exhaust port with the front of the A port now angled that way.
I think I described it wrong. If u look at the flow now it more like the pic you have posted. Before it was angling towards the rear when flowing I removed just a little going back into the trans with the polishing bit and it pulled the flow around. I didn't widen the ports. Hope this makes sense.
 

Latest posts

Top