Deets066
Firewood hack
Nope, original 044 pistonThat a new 064 piston?
Nope, original 044 pistonThat a new 064 piston?
YupIs that oem lol?
First screw the long puller nut to the tool then to the shaft (clutchside ) and continue to unscrew the spindle of the tool until the all tool sit to the bar studs, continue to unscrew and the case is close.I like it as a splitter too...it's kind if a pain as a puller....but still does the job, just takes a little practice.
Walked into an out building at the farm and found this, charged up the battery some air in the tires and fresh gas
and she is a runner!
Ran it today and took some saws to start on the dead fall on the property. Not much good firewood but it will make an amazing bonfire.
Is that OEM paint.Just painted up the 038 magnum View attachment 419677
Waiting for the paint to cure for a day or two
Well I got two crank cases, three cylinders, two top covers, and I think one of everything else haha. Got to flush out and check the crank cases.I just got a box o 026 myself, 3 saws in a box.
The worst looking one runs.
Oops! That can't be goodA 390xp with oiler trouble, a 362 needing a service/clean, 201t with no spark, 201t that won't idle and 201t that needs bearings seals and gaskets and possible crankshaft after a well intentioned (?) attempt to help by removing clutch the wrong way with a breaker bar, saw was also ran with missing clutch springs and brake engaged and the wrong guage chain
Walked into an out building at the farm and found this, charged up the battery some air in the tires and fresh gas
and she is a runner!
Ran it today and took some saws to start on the dead fall on the property. Not much good firewood but it will make an amazing bonfire.
What is the little foot leaver for?
Enter your email address to join: