Thanks Grizz, My dig meter showed 122v at both outlets without any draw. Will check upon load & see if there is a drop. Also upon browsing on the occasional pop sound, they say it could be the valves not being seated fully due to heat over time. I blv it can be easily fixed by filing the valve seat stem.
-----
" In my experience if it feels like a engine when you pull the rope then it's an engine that should start. If it can't start with spark and fuel then compression may be in question.
If it does start but becomes unstable after warming up for a few minutes, eventually stalling and feeling easier to tug on the starter rope then the valve have hobbed the seats. The valves get too long to seal when heat expands them, especially the exhaust valve. When this happens compression crashes and the engine dies out. Eventually they won't even seat well enough for predictable starting if you can nurse it along long enough.
The remedy is to grind the valve stems to restore lifter clearance. You will get to clean the head and piston top at the same time. Unless the cylinder wall has something significant going on leave it alone. Put it back together preferably with fresh gaskets and you have a good shot at the block going for decades more. Remember to torque the head bolts to spec. Many carburetors have been needlessly rebuilt chasing this since it can seem like the engine is running out of fuel.
Unless the valve spring retainers give you a hard time it should fit into a 2 hour session."
--------