026 Throttle Bar Installation Help

[watermole]

This is my first post on the site. I recently picked up a 026 that didn't have a carb or throttle bar. I got a Walbro 194-1 and a throttle bar. I cant figure out how to route the bar to the carb, any help would be greatly appreciated, Pics would be a great help. Thanks again.

 

[kam]

PM me your email address and I'll send you a shop manual and parts list.

To install the throttle linkage you must remove the black piece on top of the handle (small self tapping screw
from underneath) .

I think you may have to remove the filter also.

 

[76Paw]

I need them too.

PM me your email address and I'll send you a shop manual and parts list.

Kam,

Would you mind if I send you my email address also for that 026 shop manual and parts list. My saw is getting weak, hard too start, and low on compression. I'm going to tackle my first rebuild, and those would really help a lot.

Thanks in advance.

John

 

[watermole]

026 Throttle Bar

Thanks guys for the help, I figured it out, now messing with the control bar(no spark)???:frown: