026 wide open issues

[Chainsaw Jim]

This is usually a problem caused by the wrong pump diaphragm.
Grab your old gasket and diaphragm and see if any of the parts left in the rebuild kit bag matches perfectly.

 

[Rquick]

None of the pump diaprhagms matched perfectly to the old one so should I put in a different one it was a k10 wat rebuild kit the carb was a 22 c

 

[Chainsaw Jim]

Are you also saying the one you used didn't match?

 

[Rquick]

Not exactly one piece in it did it was the clear blue plastic one not the same material as original one. Should I try that one and this was the only kit I was told would work with the Walbro 22 c

 

[HarleyT]

use it

 

[Rquick]

Ok thank you I'll put it in and give it a try.

 

[Rquick]

Ok that worked it's running good now but for some reason it won't turn off when I flip it up to stop all the wires are connected and everything looks right what else would cause this ?

 

[HarleyT]

Look where the wire contacts the flat spring when you flip the lever up to stop, and buff the bullet wire end with sandpaper, maybe slide it a hair to the side. Also make sure all of your ground strap wires are secure and tight.