They do have a problem. If they had put those good parts in to begin with we wouldn't have to order them. Mike
FLCM, i'm just curious if you put the bigger pump in would it empty the bar oil sooner then when you run out of gas? just curious, let us know after you run a few tanks through.
snowdog
Have to bump this one up. Have a call into the dealer for the parts. My bar and chain tend to be very tan by the end of a day of cutting oak, this will/should help. Andy, do you or others know what a max output on the oil could be vs. gas? I'm wondering if it would really even be smart to put on the HO or just go with the standard.
Chad
Have to bump this one up. Have a call into the dealer for the parts. My bar and chain tend to be very tan by the end of a day of cutting oak, this will/should help. Andy, do you or others know what a max output on the oil could be vs. gas? I'm wondering if it would really even be smart to put on the HO or just go with the standard.
Chad
Just put that on and tried it . 1. The broze bushing is soft, roughed up the outside the the inside was fine and rolled smooth. How do you guys in the shops take care of these? 2. GOOD LORD that's some oil!!! Make sure you start off about half and go up from there. With the stock one in there, I really didn't have even much oil coming off the bar when free rev. Now, the cover was wet with oil when free rev.. I'll have to play with it till I find out where it is giving enough oil but not running out of either the tank or the cover.
Thanks again, great tip.
Chad
Enter your email address to join: