Well I planned on getting an 066 for a milling saw but didn't have all the money yet so I bid on a parts saw so I could tear it down and know something about the 066.I bid on one on E-bay that had some parts gone but the guy said he had put gas in carb and it had fired. It was one of a lot he had bought from a retired logger . Well I got it shipping and all for 205$.It needed a top handle and a few other parts so when it came in I thought it did not look to bad and put a handle and E clip and washer on the sprocket but the choke switch would not work right so I took off the carb cover and the carb was surrounded in mudauber nests I cleaned them off put it back together put some gas in it 6 tries and it fired took the choke off 2 pulls and it started and ran great .So then I cleaned it up and put on the parts I found it needed,
sprocket cover,top handle,chainn adjuster,chain catcher ,4 screws,manuals and a carb kit total cost 319$. I already had a bar and chain for it.Here are the before and after pics
sprocket cover,top handle,chainn adjuster,chain catcher ,4 screws,manuals and a carb kit total cost 319$. I already had a bar and chain for it.Here are the before and after pics