No, I went with the 572, but havent been using it much. The trees are normaly not big enough, and we cut them at 3 meter length so there is not that much bucking. But I like the C85 chain so I will convert a jonsered 2260 from .325 to 3/8.
All in one Stihl bar adapter.
- Thread starter Homelite410
- Start date
Help Support Arborist Forum:
Looking for adapters? Large stihl 3002 to Homelite 1050A?
Small Husqvarna (like a 55) to stihl 3003?
I've tried some aftermarket but they were all garbage.
Small Husqvarna (like a 55) to stihl 3003?
I've tried some aftermarket but they were all garbage.
I figured with the responses on this thread, I've just been having bad luck with them lately.
For a 1050 if you are just using a short bar get a harvester bar. The work fine
I am not sure but I may have found a way to run a Husqvarna C83 chain on a stihl saw with the 3003 mount. This bar https://www.oregonproducts.com/en/versacut™-guide-bar,-18"/p/180vxlhd025 and this chain https://www.husqvarna.com/us/chains/x-cut-c83-050-gauge-3-8-pitch/
Ok, I am not in an urgent need for a bigger chainsaw, I have a Jonsered 2260, but havent used it for at least 5 years. Have order a new rim, and a 3/8 16 inch bar. Have a C85 chain. Hope this will work. If not I look at the 400, is a bit heavier than the 362, but not mutch, but weight is always a isue for me.
@Maintenance supervisor I was thinking of trying picco super on my jonsered 2260 but a norwegian motorsawguru told me that ‘’ 3/8 low pro chain runs very good on a 60 cc saw but the chain doesent hold, they breaks. So I am in the think box. But regardless, how mutch for an adapter from jonsered 2260 to stihl 3003 mount, shipped to Rogaland , Norway?
