chain/bar innerchange? 3/8 pitch .050 gauge same link # Poulan/Echo/Craftsman

[Acornhill]

i have a Echo cs-670, Poulan 3400 & Craftsman 3.7 (3700). They all have 3/8 pitch, 050 gauge and same drive link #'s. Will the b/c innerchange with one another? 18" 66 link, 20" 70 link and 24" is 81 link.

 

[peters]

Not sure if those saws use 3/8 low profile but 3/8 low profile and 3/8 normal chain don't interchange. I know my CS400 has the low profile.

Consumer grade saws tend to have the low profile stuff.

--Peter

 

[ray benson]

Look at Baileys site - Bar selector
The bars will interchange on the saws, as they use the same D176 mount.

 

[SawTroll]

I don't know either, but I notised that all those bars are a bit short for the called length (the dl count tells it).

One thing is regular 3/8 vs. 3/8 lo-pro, another is if the bar mount patters match.....

 

[SawTroll]

Look at Baileys site - Bar selector
The bars will interchange on the saws, as they use the same D176 mount.

Ooops, I was a bit slow!

 

[o8f150]

Ooops, I was a bit slow!

so whats new

 

[Fish]

so whats new

Ouch...

No it looks like the op was talking about the bigger 3/8s...

 

[Acornhill]

Yup, checked on Bailey's and they are a match, now i can swap my three bars between the echo, poulan and Craftsman. 18", 20", and 24" thanks everyone

 

[SawTroll]

Look at Baileys site - Bar selector
The bars will interchange on the saws, as they use the same D176 mount.

I was too lazy to do it, but you wasn't.

Send some rep to Ray guys! :msp_thumbsup: