Just near Bunbury mate. It has a bent decomp pin so deciding wether to plug it or replace itI’d suggest you leave it in, it reduces the load on the recoil system. Where in WA are you?
The piston and cylinder look to be in good condition, I popped a carby from another 660 I have and got it to pop a few times with a few drops of fuel down it so I think a full rebuild is on the cards. Just gotta decide wether to go chineseses or oem there is a lot missing but it’s the only project saw I have left to work on can’t keep avoiding it any longer haha
If you go the Chinese carb route, buy 2 at once, that way you will probably wind up with one that works... maybe.
Lucky you. It took 2 to get a good one for my Lincoln engine drive welder. First one, the drill ways weren't finished but the second one was.
Never did a carb on a chainsaw so I cannot speak for them.
Enter your email address to join: