Dad got this saw at an auction $5. Though I'd fix it up. Vacuumed base and the base gasket was leaking pretty bad. Repaired that, cleaned carb, new plug and washed everything surgical clean. Set coil gap (yes it has spark) new fuel line. Won't start not even a hint of firing. Checked compression, got a repeatable 120psi. Piston looks good intake and exhaust side. Took muffler apart everything was clean. Figured ok, must be timing issue. Check flywheel and keyway both look nice. Then looked at static timing and found magnet was way far away from coil pick up when piston at TDC (see picture, yellow dots indicate magnet side of flywheel) anyone have any idea if this is normal? It looks like they replaced coil but it does have spark