camel2019
ArboristSite Guru
Does its matter watch chain pitch you use one a hard nose bar looking at getting a new durarail bar for my old pioneer 620 and cant find any .404 bars only 3/8. so as long as the gauge is the same does it matter
Oregon k095 mounts work I have a pile of pioneer bars but most of them have seen better daysMay have to find a older used bar and modify it.
I have a brand new rim sprocket clutch drum sitting here waiting to go on 1 of the 3 620's I have. Could go with 3/8 if I wanted to but like the idea of a big .404 full chisel especially with these low RPM saws.The gauge of the chain and bar have to match, bar doesn't care about the pitch but the pitch of the drive sprocket and the chain have to match.
This. If you’ve got a 3/8 drive sprocket on the clutch end, gotta be a 3/8 chain.The gauge of the chain and bar have to match, bar doesn't care about the pitch but the pitch of the drive sprocket and the chain have to match.
The standard pioneer 600 series spur sprocket is for .400 pitch chain but works with .404 I was lucky to find a NOS Oregon rim sprocket clutch bell. looks like I might have to run either a pioneer bar with .063 .404 or go to 3/8 .058 the dealer says Oregon no longer makes the 22 inch duracut even though you can still find it on their website it was the only .063 k095 mount duracut they had.This. If you’ve got a 3/8 drive sprocket on the clutch end, gotta be a 3/8 chain.
Enter your email address to join: