ok i bought the huskvarna sharpening kit for 3/8 in chain H80
comes with 7/32 round file which is what my manual says is right size.
Th
I have tried every which way to put the little guide on the chain but it doesnt set low enough to allow file to go into the tooth of the chain. When i push file on the rollers it actually files off the face of the cutter.
What am i missing here??? Instruction are poor.
Shouldnt file be below cutter and into notch????
Help
Seem like it would be easier just not to use guide and push file in by itself
comes with 7/32 round file which is what my manual says is right size.
Th
I have tried every which way to put the little guide on the chain but it doesnt set low enough to allow file to go into the tooth of the chain. When i push file on the rollers it actually files off the face of the cutter.
What am i missing here??? Instruction are poor.
Shouldnt file be below cutter and into notch????
Help
Seem like it would be easier just not to use guide and push file in by itself