Hybrid Build

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
The d- jugs must have fatter transfers ,i had to grind much more than that to fit ,you got lucky if that is all that needs removed .
 
Merry Christmas to all! Didn't really think I would have time to work on any saws! Well after dinner, desert and clean up I had to escape for a while! I got the piston and rings on and the clips in.
cf12cf99fca185cc37712c0e73f92198.jpg
Then came the test. I put the cylinder on with no gasket. The squish was between .016-.019. Ill check again tomorrow and see if I get the same. I like the .019 but not the .016!
31cb9921f0e949616515913bd285b9bb.jpg
Mounted the muffler to measure for spacers. Looks like 3/16" on mine.
4662cc4ed0be988dbfdbe79e0301031a.jpg
c475ed08e06ba4f26e0625439cc9b533.jpg
 
Ok I went back and took the rings off the piston and used some grease on the piston to hold all four peices of solder.
183294c72b184a56cdd2b80f4cfe6b70.jpg
This way I got a consistent .013. Hmm now what to do? Gasket measures around .018. A beer can measures around .004.
 

Latest posts

Back
Top