Hybrid Build

[KG441c]

Valspar Tractor / Implement paint in Husqvarna Orange and unlike Stihl OEM paint it actually stays on

 

[hseII]

Look what I found nib 440.

Show Off.

 

[Adirondackstihl]

 

[hseII]

You Toos.

 

[Trx250r180]

The d- jugs must have fatter transfers ,i had to grind much more than that to fit ,you got lucky if that is all that needs removed .

 

[Adirondackstihl]

The d- jugs must have fatter transfers ,i had to grind much more than that to fit ,you got lucky if that is all that needs removed .

This is a D jug.
I used a burr to grind and a sanding wheel to blend everything afterwards

 

[redfin]

This one isnt a D but it was alot to take off.

 

[redfin]

I tried to find a pic of the flywheel side also. No bueno.

 

[glock37]

The d- jugs must have fatter transfers ,i had to grind much more than that to fit ,you got lucky if that is all that needs removed .

"D" juggs yes are Fatter !!!!

 

[Adirondackstihl]

This one isnt a D but it was alot to take off. View attachment 472555

I didn't have to touch the PTO side on either Hybrid I've built...

 

[Adirondackstihl]

But now that I look.......I might just clearance the PTO side as well.

 

[mcobb2]

But now that I look.......I might just clearance the PTO side as well.

Race weight?

 

[Stihlofadeal64]

View attachment 472465 View attachment 472466 Valspar Tractor / Implement paint in Husqvarna Orange and unlike Stihl OEM paint it actually stays on

Resto-magic! Eww lah lah!

 

[Adirondackstihl]

Okay, so here's the PTO side......

 

[Stihlofadeal64]

Hybrids, Hybrids -- bring on the Hybrids!

 

[redfin]

I didn't have to touch the PTO side on either Hybrid I've built...

The base on this one got a little extra trim.

 

[Stihlofadeal64]

Merry Christmas you Hybrid dudes!

 

[PA Dan]

Merry Christmas to all! Didn't really think I would have time to work on any saws! Well after dinner, desert and clean up I had to escape for a while! I got the piston and rings on and the clips in.

Then came the test. I put the cylinder on with no gasket. The squish was between .016-.019. Ill check again tomorrow and see if I get the same. I like the .019 but not the .016!

Mounted the muffler to measure for spacers. Looks like 3/16" on mine.

 

[Adirondackstihl]

I used 3/16 alum flat last time. Sadly I never took any pics. I'll make sure to this time.
I like to make a one piece spacer. So much easier!!!!!
I grabbed some stock from work yesterday before I left......

 

[PA Dan]

Ok I went back and took the rings off the piston and used some grease on the piston to hold all four peices of solder.

This way I got a consistent .013. Hmm now what to do? Gasket measures around .018. A beer can measures around .004.