I am fixing this low-hour 026 for a friend. I have the same saw but pro model. I got it running but his saw seems to put out copious amounts of bar oil compared to mine. His oil pump is not adjustable. Can anyone tell me judging by the photos if his saw is within acceptable oiling limits? It makes a mess and totally swamps the clutch and places where bar oil is not useful. I ran the saw for about 1 minute and made one small cut before taking these photos. The saw had been entirely cleaned beforehand. Wonder what everyone's thoughts are on this because I often read that you can't have too much bar oil flowing but I will have to take the clutch drum off now after 1 minute of run time and clean it before it can be run again. Is it time for a new pump or can this one be throttled down? Thanks!!!