jonsred 630wont run

[[email protected]]

so no thoughts on if the 2 different pistons would make a difference?

waynehttp://www.arboristsite.com/attachment.php?attachmentid=75102&d=1217200284

 

[jeeptj19992001]

getting gas into the cylinder?

 

[[email protected]]

it wont run but if i take the plug out and run the saw from the clutch nut with a drill it has great spark and a compresion test shows about 140 psi compression
and yes to fuel plug is alway wet when i pull it out
wayne

 

[jeeptj19992001]

flooding...will not run.....carb needs to be rebuild.....had that problem w an 041....too much gas

 

[[email protected]]

well after alot of pain the saw runs it was the piston i bit the bullet and bought another piston and this one was just like the one i took out and the saw started right up piston on right is oem one on left is from baileys