Bought a well used HT 75. Has low compression about 75 PSI. Still runs and cuts good.
Like to know what maintenance is important to do here. Does anything in the shafts need greased? Do the bearings in there need replaced? I see a couple MM of play a the end of the output shaft where you pull the cutter heads off.
There's a little play where the thick boom shaft meets the 17" shaft coming off the engine. Is that something that needs attention asap? Like to keep this pole saw going for a couple years if possible. Planning on looking around for a cylinder and piston/rings. Any feedback about maintenance and parts is appreciated. Love the saw. Gonna use it mostly for trimming very tall bushes with a hedge trimmer attachment.
Like to know what maintenance is important to do here. Does anything in the shafts need greased? Do the bearings in there need replaced? I see a couple MM of play a the end of the output shaft where you pull the cutter heads off.
There's a little play where the thick boom shaft meets the 17" shaft coming off the engine. Is that something that needs attention asap? Like to keep this pole saw going for a couple years if possible. Planning on looking around for a cylinder and piston/rings. Any feedback about maintenance and parts is appreciated. Love the saw. Gonna use it mostly for trimming very tall bushes with a hedge trimmer attachment.