Deuceindtown
ArboristSite Lurker
A few weeks ago, had a lot of water in the firebox making the ash a slushy mess. Cleaned that out and scraped the side and uncovered a pin hole. I ended up patching it with JB weld extreme heat. Yesterday, came across similar issue. Scooped it out again, but this time on the right side. Only there are three pin holes in about a three inch area. Or sure what to do now. These are near the middle of the sides, no welds around it. Hit it with JB weld and hope I don't get more leaks then cut and patch after the burning season?? Do it now and hope for the best?
The unit is 9 years old. Seems like junk metal was used.
The unit is 9 years old. Seems like junk metal was used.