About the aluminum can method — be sure to file/round the sharp edges before sliding seal over it. Just saying
A lot of products come in those clear plastic clamshell packages, I’ve used that material as a sleeve before. And microfiche film. You can install the oil pump (with seal installed) without a sleeve if your careful. Gotta have the right technique though.Or a plastic bottle. I use overhead projector plastic sheets for seal guides. I still use super fine sandpaper to dress all the edges. Works great. Beer cans seem to be a good place to start though...
I think there should be an o-ring in there somewhere on the outer diameter of the seal holder. It would appreciate a replacement.How hard should I hit the bolt with a hammer? 1,5kg = 3,3 lbs
I also tried a lighter plastic hammer with the saw in one hand but no luck.
Sprayed some WD40 yesterday.
What do you think of the flywheel, there is also some wear from the starter, there might be a problem as well in the starter.
Edit:
Got it! some heat, took the flywheel with vice grip and 2 gentle hits...
It's leaking some air between the inner metal ring and the inner plastic...
I wonder how bad it was under a vacuum![]()
Enter your email address to join: