Should I trade my 028super for a husky 350

[Arnett95]

I hear their tough saws is it worth rebuilding or not? personly idk this is my first one and so far im not impressed

 

[SEAM]

If it is only the clutch, what do you mean by "rebuild"? What happened to the clutch?

 

[sawfun]

Your gonna find that a lot of folks like the old 028 super. They may be heavier and some slower than the newer 50cc hotshots, but they still do the job and do it well. The old Mac's are heavy and slow but they seem to have a following. So maybe older and slower aint all bad.

 

[Big_Wood]

I could make a 350 last just as long as an 028. What do you guys think about that 028's are just more idiot proof.

 

[sawfun]

So can I, but the 028 is still a better made saw. Just not necessary better performing.

 

[ReggieT]

So can I, but the 028 is still a better made saw. Just not necessary better performing.

Which generally equates to...better performance in the short & long run...if that's not to far of a stretch! lol

 

[sawfun]

Both saws are good its just a personal preference. I ran my 350 today with the 20" bar buried in fir and it felt like it had a bit more than my 028 super. But not a lot more considering the 350 was running .325 and the super was running 3/8. I am more of a 70cc guy though so I don't use the 50cc saws that much. If I need to limb, I usually go for a 200t.

 

[Mad Professor]

I will give you Ted Williams, Joe Dimagio, and Stan Musial rookie cards for your used Pokeman card.