ok i got the new clutch, drum needle bearing in the 066. the cling cling cling noise i had comming from the clutch area is much better now. also the chain no longer hops a bit at idle.
npw for the question if i rev it wide open i dont hear any 4 stroking sound. so i assume i need turn the h screw out a bit. i was looking at the screw is there a special tool i need to use? i couldnt get it to move with a reg screwdriver. i didnt wanna strip it out if its a special screw so i just put it away.
the plug looked like the saw was running a bit rich. but as i said theres no 4 stroking sound. i put in a new plug for good measure anyway.
any ideas what i should do here?
oh i picked up my 36" rolomatic es bar today too. man that things #####in! even the wife was like woahhhh that things huge. so naturally i said thanks the chainsaw bar is big too.
npw for the question if i rev it wide open i dont hear any 4 stroking sound. so i assume i need turn the h screw out a bit. i was looking at the screw is there a special tool i need to use? i couldnt get it to move with a reg screwdriver. i didnt wanna strip it out if its a special screw so i just put it away.
the plug looked like the saw was running a bit rich. but as i said theres no 4 stroking sound. i put in a new plug for good measure anyway.
any ideas what i should do here?
oh i picked up my 36" rolomatic es bar today too. man that things #####in! even the wife was like woahhhh that things huge. so naturally i said thanks the chainsaw bar is big too.