Stihlman441
Addicted to ArboristSite
Not bad for the middle of town wasn't going fast enough
Was wondering if the road was still there and the bridge over the creek but all good
the all aussie dribble thread!
- Thread starter masculator
- Start date
Help Support Arborist Forum:
Was wondering if the road was still there and the bridge over the creek but all good
Man did Geelong get some rain! I suppose it gave the truck a good clean.
tungsten carbide chain does it again easy
Plane tree roots dont care if your supe dupa axe man they bounce any steel blade
busy day for crew soxin butt ugly pines
Plane tree roots dont care if your supe dupa axe man they bounce any steel blade
busy day for crew soxin butt ugly pines
Thats a sweet grab on your Terex
small leaning saplings can but big solid stuff i wouldn't know,,,,, Stihlman441 would have dropped a few tho
whats the collective noun for condoms ?
anyhoo forgot to mention my great day on the job yesterday,,, im strolling over to look at a job thro a carpark when under my foot Bang! a bit surprised i turn to look at the source its a used dinger,,,,i then realize im standing in dumped littered field of them,, eeewwwe
later same same day on foot i spy a huge dog **** and so step aside to avoid it,,,, putting my foot in hole that turns twists my ankle,,, down i go in great pain tho able tuck roll miss the turd ..
anyhoo forgot to mention my great day on the job yesterday,,, im strolling over to look at a job thro a carpark when under my foot Bang! a bit surprised i turn to look at the source its a used dinger,,,,i then realize im standing in dumped littered field of them,, eeewwwe
later same same day on foot i spy a huge dog **** and so step aside to avoid it,,,, putting my foot in hole that turns twists my ankle,,, down i go in great pain tho able tuck roll miss the turd ..
WidowMaker_1
_____________
- Joined
- Apr 18, 2014
- Messages
- 1,424
Where's the pictures of you pressing the bearing in chipster ...don't hold out, no piccys it never happened
Congress. Packed with dickheads.
VinceGU05
PSA vitim.
lol dingers... havent heard that word for a long time
David (saltas)
Addicted to ArboristSite
Nothing to report, lots of people out of work, I can't get a full weeks work, some I'd better than none
sent from my Android Phone
sent from my Android Phone
chippy
Addicted to ArboristSite
Got it into the hub on the car but inserting the axle stub is a bit more difficult so I've had to remove the control arm from the car. Was a bit worried I may push the inner race out of the outer race without a solid surface behind it, such as my garage floor.
chippy
Addicted to ArboristSite
lol dingers... havent heard that word for a long time
Frangas would be also acceptable, and I bet you haven't heard that even longer.
That's one lucky ride on mower! can't say the same for me poor old VK bugger! lol..I knew it was going to go I just didn't know when I tried to get an arborists to take it down but he didn't show up it did hit my powerline on the way down but all seems fine lucky..
Oh well it's right next to me wood heap so that's a plus ha!
Oh well it's right next to me wood heap so that's a plus ha!
och sos the VK
u say it hit powerline was that insulated service wire or farm swer hv stuff to transformer as i see pole typical of swer best check the clamps fitting by eye
u say it hit powerline was that insulated service wire or farm swer hv stuff to transformer as i see pole typical of swer best check the clamps fitting by eye
It comes off the transformer at the mill its black insulated looking stuff clamps and fittings look ok to me but I don't really know what I'm looking at. might get em out to look at it just to be safe..
VinceGU05
PSA vitim.
Naa bout the same. [emoji1360]
black insulated hmm could be low volt 415 abc but if going to tranny then should hv 11kv,,,here look over this link or put your tongue on it
see if buzz or whack oh care if poles on your land a call out may cost $ check service fees policy 1st Saltas could help he got better elec understanding
https://www.sa.gov.au/topics/water-...ustry/powerline-safety/identifying-powerlines
chippy
Addicted to ArboristSite
Minor problem.
Got the stub axle in without damage...all good.
But forgot to put the large circlip in the hub first that retains the bearing in the hub....and now I'm in strife....
Any suggestions?
Too wide to spread it without destroying it and if I have to belt out the stub axle now I will destroy the bearing.
Got the stub axle in without damage...all good.
But forgot to put the large circlip in the hub first that retains the bearing in the hub....and now I'm in strife....
Any suggestions?
Too wide to spread it without destroying it and if I have to belt out the stub axle now I will destroy the bearing.
