Wheels/casters

[hopm]

I have 8 casters on my mill which is a Baker EZ which has long been discontinued. I have moved and shifted until I am out of options and have come to the point I must find a replacement. Do you folks have a suggestion for a type of wheel and a source? I have included a picture of the original wheels which have lasted close to 15 years.
Thank you in advance for your response!!

 

[Jim Timber]

What size are the wheels?

 

[kimosawboy]

These should be the same guys....just give em a call.

http://www.baker-online.com/

 

[hopm]

4"x 1.25"

 

[Jim Timber]

Do you know anyone with a metal lathe? You could get these and shave em down if needed.

http://www.surpluscenter.com/Caster...X1-5-MOLDON-RUBBER-CI-WHEEL-1-3-16-1-4058.axd

 

[PhilB]

Check Grizzly.com or mcmaster.com

 

[Fallguy1960]

They look like roller blade wheels to me.

 

[Jim Timber]

They look like roller blade wheels to me.

I thought that at first too, but they're wider than what was pulling up for that application.

 

[MontanaTed]

https://www.waresdirect.com/product...kURL=froogle&gclid=COqw2LSc_8kCFU1gfgodmMQLWA

Here's a link for some 4 x 1.25 Urethane wheels with 300 lbs capacity, might not do the trick though looking at the set up you have.

 

[PhilB]

Here are two possibilities:
Phil

 

[PhilB]

Here's some other choice's:



These are less expensive. You would just use the wheel. The axel bolts are probably metric, so you may have to re-drill the holes. They are available at grizzly.com.

 

[clintb]

I use these on my bandmill.
http://www.ebay.com/itm/Four-4-V-Gr...033647?hash=item3d0b4458ef:g:XF8AAOSwNphWZyjX