This is my First post after visiting the site for the last year. I have cut wood most of my life for the occasional fire in the fire place and have been well served by my 029 super and 025. This is where the story gets interesting. I got an owb last fall and my 20 year old stihls were a little worn out for that amount of cutting(15 plus cords). I started researching online for saws and stumbled on AS. I sold my saws on Craig's list and still not fully having cad bought a great little rebuilt ( new p and c) 036 pro running a 20" bar. Being a 2 saw kinda guy and running into the opportunity to cut up a massive ash tree(4' at the base) I bought a new 7900 running a 28" bar from Curtis. At that point I started to visit the site on a daily basis and start getting cad bad. I have since bought a used 346xp ne which I have a 16 and 18" bar for and recently just bought a new 372xp xt since I couldn't find a decent used one on Craig's list all summer. My question for you all is out of the above mentioned saws which one would you have woods ported? Keep in mind for the 15-20 cords I'm cutting a year I don't need the saw line up I already have and definately don't need a ported one, but I've got CAD.