Search results

Which piston would you guys use for a 372 xp. I'm doing a little experimenting with a AM cylinder before I use the new OEM cylinder I have. These pistons came with the saw that was a xtorq now being converted to a 372xp OE. The windowed piston on the left looks nicely made and the rings have a...

Which piston would you guys use for a 372 xp. I'm doing a little experimenting with a AM cylinder before I use the new OEM cylinder I have. These pistons came with the saw that was a xtorq now being converted to a 372xp OE. The windowed piston on the left looks nicely made and the rings have a...

Finally got the time to build some jigs to cut the squish band on any of the saws I have on hand and cylinders I most commonly work with. Only had 2 pieces of 4" diameter aluminum round to use so I pissed around for a bit and made the jigs work for 5 different husky cylinders. 288, 372xp on one...

Over the last couple days I have been playing with a 55 and wanted to try a 028 stihl pop up piston. I first set up the cylinder and cut the base so it would be .040 thousands with a base gasket and stock piston. Then I started fitting the 028 piston. I cut .030 of the main part of the piston...

Just rebuilt a 2007 Husky 55 that I had given to me in a box all torn apart. Crank bearing were toasted along with the cylinder and piston. Did a complete tear down. I had a Hyway CP kit I bought a year or 2 back that I decided to use on this saw. The guy at the factory forgot to finish...

Has any one here bought caber piston rings from Northwood Saw. I did last year and I know they came in a small white envelope . Now they may buy in bulk and repackage that way . But there is no marking on the ring to indicate they are real caber like laser etching if that is a thing like I have...

I have two dead saws at the moment. Well one is some what running with a aftermarket top end that the previous owner threw on and didn't check the bevel on the exhaust port so it now has low compression again. I got the old cylinder with the saw and it was a 51 at the time before he put the AM...

Is there a .325 rim sprocket that will fit on a Husky 365 XT. All of my other saws are 60cc or less and are .325 pitch chain and bars. I just got a dead 365 xt that I plan on bringing back to life and I was wondering if I can just change out the rim sprocket to a .325 pitch sprocket. I have...

Looking for a brake guard for a MS362. Does anyone know if a 441 or 361 or other stihl brake guard will fit. Is the 362 that much different then the 361. I know some parts carry over to new models but this 362 seems to have very little support in the aftermarket seen. I am trying to source...

What husqvarna saw came with a AV spring mounted to the front of the engine case just below the muffler. My father has a old husky and there is no decal on the saw any more. I haven't seen it it a few years so I am just going off memory. It has a more square shaped recoil and the recoil...

I picked up a couple of husky saws just recently and in the process of deciding what to do with them. The saws were picked up by my father when he was on vacation and I did not see them until about 2 months later. Husky 51/55 and a 340. They both run and seemed to cut good was his feeling when...

Been looking around the site a bit trying to find the right answer to my saw problems. Nice site by the way. From what I have been reading it seems like I have the carb boot problems along with maybe the carb being crap also. Bought the saw used 2 yrs ago for a smoking deal. Took it home to...