Search results

Looking for any service manual, parts manual etc for Partner K700/650 concrete saws. Thanks for any help. Brian

I've borrowed a friends ht131 several times. Have cut numerous 10-16" limbs with ease, seems to chew right through with very little throttle or effort. It is heavy and your shoulders know it the next day if you do a bunch of cutting. That tool has allowed me to cut stuff down and fall...

Hey Guys, I have a next to new Husqvarna 51 that I'm working on. It was a "non-running" saw that literally just needed new mix to get it going again. I'm leaving the stock 51 piston/cylinder as it is in almost new condition but am doing a few mods to give it a little more pep. It only has...

Just did that myself a couple days ago... Maybe we can start a support group. Lol

Have an 066 that needed the oil worm gear replaced and also did a dual port muffler at the same time. I pulled it apart quick replaced the worm gear, put the muffler on, took all the covers off to clean up, then reassembled. I go to pull the rope and its locked up tight. What... I inspect...

Yep got it... Thanks.

I sent you a pm this morning. Did not get a reply.

When you start. Any available wood is good wood. Don't get hung up on getting the right wood.

A dime tip and 1/4 sprocket on a ms170 is an excellent economical starter setup. Full house 1/4 drive, oregon 25F chain is nice.

A king arther tools lancelot (google it) grinder chainsaw chain conversion. Works very well for bear fur. I use mine a lot. Use with caution as your fingers are A Lot closer to the meat eating portion. I have a glove that got a nice trim once. Was a wake up call. Slow is better.

Nice. On your base make sure to angle your cuts so the water quickly drains away on all sides to last longer.

I have some chains like that too. Also smoother in general. I bought mine years ago from a guy already done. It was only pennies more per link at that time.

I'm having a hard time following this. Which ones do you have still for sale and what is the asking price and condition of each. Thanks, Brian

Looking for oregon 59ac chain. Need 77dl minimum. This is .404/.63 chipper chain. What's out there? Thanks Brian

Thanks a million Bob! Never sorry. Your pictures are very helpful and always innovative. Brian

Bob what size bolt do you typically run? Any chance you have a picture of one of your bolted on bars? Thanks

Hey Guys, thanks for your help. I tracked down a plug and put it in. It held pressure rock steady. So alls well with the rest of the saw. Then I put the decomp back in with a light coat of high temp red rtv on the upper threads and washer. Let it sit for a couple hours and retested. It...

Gregg, I was talking about drilling the tip in between the rivits of the sprocket for mounting to a grandberg mill. Like Malloff talks about in his book. Thanks

Hey Guys, I'm pressure/vac testing my 066. Vac test holds 7.5 with no change for 1 minute. Pressure test drops 1.25 psi (start 7.5psi) in 1 minute. Soap test shows slow bubbles at what looks like the base of the decomp. No other bubbles at intake, impulse, seals, cyl gasket, exhaust and carb...

Are you able to drill the tip on this or is it too tight of clearance?Just looks small to me.