Search results

Sent you a message on OPE.

Left hand start shouldn't warrant a SP125 head cover. 795L saws were set up similar to your converted 1-76. Standard shrouds will work fine.

Sweet build! Can't wait to see it cut. Can you please link the bar thread? I couldn't find it via search.

Husky full wraps are stupid cheap, search 588946201 and look for free shipping.

PM Sent

I'm looking for a MS462 IPL. Thank you!

Digging this one up from the beyond. Does anybody have the 2100 hot saw pictures Ken's talking about? His email address is no longer active.

Still looking, The TI Ray had was for M6x20 change out to M6x25 on the late 064/066 saws. I'm looking for the TI on M5 x20 to M6x20.

Hey Guys, I saw a reference on here from 2006 on a technical bulletin/information from Stihl on the change from M5 Cylinder hold down bolts to M6 on the 064. Does anybody have a copy of that TI? Thank you! Scott

Thanks Mark!!

Do any of you guys have CP-55 or CP-70 IPL's you would be willing to share with me?

Figures... The one Mac in my collection that I didn't get a bar with and I didn't try mounting it on. Perfect fit. Oil and adjuster holes line up perfectly

9.5 mm or 3/8" , it's .058 gauge so that kind of rules out Stihl.

33441

Hey Guys, I bought a NOS Oregon roller nose bar from a small engine shop that was supposed to be a MAC pattern. I tried mounting it on my 125, 790, and 550. The tail doesn't clear the clutch and when holding the bar plates up to the bar the adjuster and oil holes don't line up. The seller...

I'll take it. I'll send you a PM.

I did some more digging after I posted the question. The part numbers are different for both the crankcases and the bearings. I also found a post saying the later saws had larger bearings added for better durability. So maybe the bearing bore is different between the older and newer saws....

Is a P60 crankcase the same as a Pioneer Pro 655 crankcase? Both sides? One side?

I got them off with a bit of heat from the heat gun on the metal and using a rag for some extra grip on the mounts. The rubber separated from the male end of the mount on a few of the mounts on another saw I was working on and I used a cutoff wheel on a dremel to cut a slot in, and then I just...

Are there any tricks to getting the rubber av mounts off a p series saw without destroying them?