fl cracker
Addicted to ArboristSite
- Joined
- May 29, 2016
- Messages
- 1,615
- Reaction score
- 1,092
Saw 2 036 pro with pro top end and decompression.i aquired saw with a bad cylinder and piston a ring broke and gouged the cylinder by transfer and trashed cylinder and piston.i tookvsawxapart cleaned saw installed used oem cylinder and piston/ new caber rings/ ported muffler/ new fuel line/ cleaned carb/new pull rope/ new sheetmetal oul rail there at bar studs/ new cylinder gasket vacum and press teasted after checking bearings and seals/ only diff is it dont have mag starter cover and compensating carb like a pro model/ does have adjustable oiler saw oils idles and runs as it should also saw had a broken nuffler bolt in top left of muffler the i drillex and helicouled muffler.this is the muffler not the case fyi.also saw has a brick red filter cover and a orange cylinder cover cuz i took my cylinder cover off my personal pro saw when i put pro topend on this sawbeing my saw has a non decompression cylinder.400 shippex family and friends lower 48