• Please be aware that we have recently gotten a wave of users that, when researched, are found to be from Nigeria. They are trying to sell products and asking to be paid through Zelle or Venmo leaving users with no recourse if they don't ship the product. If you suspect this activity please contact admin and we will research their information to verify their location.

ArboristSite.com Sponsors
Peak Industries


FTec 372 cases

Gord404

ArboristSite Operative
Joined
Apr 10, 2018
Messages
219
Age
67
Location
Chemainus B.C. Canada
Anybody have trouble with these, 2 out of 6 cases had pin hole leaks in the casings which unfortunately was not found until final pressure-vac test- did write them but no response yet and not going to give a lot of time pursuing a refund or whatever- last time I had a problem with one of their products waisted a lot of time and got me nowhere.
 

Gord404

ArboristSite Operative
Joined
Apr 10, 2018
Messages
219
Age
67
Location
Chemainus B.C. Canada
the one on that side was the size of a small pin and the other one was on the opposite side of the other case you could pass a small copper wire through, yup as long as we keep buying it and they rake in the $ they have no reason to improve, - into my scrap casting barrow they go not to be bought again.
 

Attachments

alexcagle

Cutoff Saw Specialist
Joined
Dec 22, 2010
Messages
6,281
Age
56
Location
Broken Arrow,OK
If it didn't cost so much, I'd say mail it back with them. Just pack 50 dog turds in there to get your point across.
:nofunny:
Here:
 

Gord404

ArboristSite Operative
Joined
Apr 10, 2018
Messages
219
Age
67
Location
Chemainus B.C. Canada
Well I generally don't buy anything critical to engine life like cylinder , cranks etc but at least I thought they could get that right, like I said it's all about the amount of $ they pull in and have no reason to improve as long as people keep buying it-- tried getting some satisfaction on 372 boot clamps that were pictured like the proper oem ones and they sent me household hose clamps 3 times in a row and said that their engineers said it was a good thing and I replied maybe the should get some new engineers... my time is a little too valuable than back and forth emails going nowhere and besides even if I did get some new cases from them I wouldn't trust using them, - having to pull down 2 saws because of these it enough to make my faith in them around zero.
 
Top