John in MA
Addicted to ArboristSite
OK, just a couple quick questions:
1. The carb (HA-135) on my XL-98 has been leaking since I rebuilt it. I don't know if it did before, becasue the saw was too messed up to put gas in. Anyway, after pulling the rope and getting gas to the carb, the gas starts dribbling out of the barrel. What might this be? Everything has been replaced, including the main needle valve. I really want to get this pain taken care of.
2. My Stihl 032ave just started dying at high speed. It'll run for about three seconds wide open and then it'll die unless you return it to idle. I've never rebuilt the carb on it. It's probably running with the original diaphragms. Am I correct to assume the fuel pump isn't delivering enough fuel?
Thanks in advance.
1. The carb (HA-135) on my XL-98 has been leaking since I rebuilt it. I don't know if it did before, becasue the saw was too messed up to put gas in. Anyway, after pulling the rope and getting gas to the carb, the gas starts dribbling out of the barrel. What might this be? Everything has been replaced, including the main needle valve. I really want to get this pain taken care of.
2. My Stihl 032ave just started dying at high speed. It'll run for about three seconds wide open and then it'll die unless you return it to idle. I've never rebuilt the carb on it. It's probably running with the original diaphragms. Am I correct to assume the fuel pump isn't delivering enough fuel?
Thanks in advance.